Weatherables PWPI-THD3-4x8DE Instalační příručka Strana 6

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 10
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 5
12
34
56
78
9
GATE ASSEMBLY INSTRUCTIONS
Always start by doing a "Dry Fit" test without gluing. This allows
you to make any necessary adjustments. Start the assembly by
inserting the rails into the first gate socket post as shown. Install
a u-channel on the first picket Feed the pickets into the slots of
the rails. Continue installing the additional pickets.
Cross measure the gate. Be sure to read the same side of the
tape rule. Failure to do so will result in the wrong measurement.
ASSEMBLY OF PRIVACY GATE
that the top rail remains inside the post if force is
applied to pull it out.
Once you have finished installing the pickets, install the remaining U-
channel in the same manner as the first. Do not use glue for the initial
"Dry Fit" assembly. Once assemly is complete measure to be sure gate
is the same width at top and bottom.
Leaving the panel assembled, carefully remove the rails from the socket
posts. Turn the first socket post up and run a 1/8" bead of vinyl glue
(included) around the inner rim of the socket approx. 1/4" down
Quickly repeat steps 5 & 6 for the other post. This may take some
assistance to do before the adhesive begins to set.
Allow glue to dry for 1 hour, cut and install the angle brace. The brace
should run at an angle starting at the lower corner of the gate on the
hinge side and run at an upward angle towards the top of the gate on
the latch side.
After the glue is in the pockets of the first gate post, flip it down
and quickly insert the rails into the pockets. Be sure to firmly
insert the rails. The adhesive will set in about 45-60 second.
Quickly measure the top and bottom of the gate as shown here.
Both measurements should be equal.
Pre-drill two holes into each end of the angle brace only. DO NOT
Pre-Drill into the gate. Attach the angle brace using two of the
provided self-tapping screws at each end of the gate.
Page 6 of 10
Zobrazit stránku 5
1 2 3 4 5 6 7 8 9 10

Komentáře k této Příručce

Žádné komentáře